Routines
| Prev: A745 | Up: Map | Next: A771 |
A75B: Code $0B: print a message at an offset from here
|
HL = IX + the two-byte offset that follows; prints the message there (A5C4) and steps over the offset: a sub-message.
|
||||||||||||||||
| A75B | PUSH IX | Save IX on the stack - Code $0B: IX is the control code; HL = IX + the offset in its next two bytes | ||||||||||||||
| A75D | POP HL | Restore HL from the stack | ||||||||||||||
| A75E | PUSH HL | Save HL on the stack | ||||||||||||||
| A75F | LD E,(IX+$01) | Read byte +1 of the record at IX into E | ||||||||||||||
| A762 | LD D,(IX+$02) | Read byte +2 of the record at IX into D | ||||||||||||||
| A765 | ADD HL,DE | Add DE to HL | ||||||||||||||
| A766 | CALL $A5C4 | Call the routine "Interpret message bytes until the end of the message" (A5C4) - Print that message (A5C4), then move IX past the operand | ||||||||||||||
| A769 | POP IX | Restore IX from the stack | ||||||||||||||
| A76B | INC IX | Step IX on to the next byte | ||||||||||||||
| A76D | INC IX | Step IX on to the next byte | ||||||||||||||
| A76F | XOR A | Set A to zero, which sets the zero flag for the caller | ||||||||||||||
| A770 | RET | Return to the caller | ||||||||||||||
| Prev: A745 | Up: Map | Next: A771 |